Using the command, I check that the hard drive is connected in rw. To make sure the mount is correct, I restart sudo reboot I specify the UUID so that you can connect the drive to any USB RPi port. To mount a disk automatically, you need to make changes to the / etc / fstab file sudo nano /etc/fstab dev/sda2 on /media/timemachine type hfsplus (rw,force)Įxcellent, sda2 was mounted in rw - read / write mode. dev/sda1 on /media/EFI type vfat (rw,nosuid,nodev,sync,noatime,uid=0,gid=0,shortname=mixed,dmask=0077,utf8=1,showexec,uhelper=udisks) dev/mmcblk0p1 on /boot type vfat (rw,noatime) dev/mmcblk0p2 on / type ext4 (rw,noatime)ĭevpts on /dev/pts type devpts (rw,noexec,nosuid,relatime,gid=5,mode=620) Install HFS + file system sudo apt-get install hfsplus hfsutils hfsprogsĬreate a point (folder) to mount the sudo mkdir /media/timemachineĪnd mount our sda2 drive in read / write sudo mount -o force /dev/sda2 /media/timemachine The unique identifier UUID can be remembered, it will come in handy later on. In my case, timeR with the hfsplus file system is called sda2. Having previously installed the operating system on RPi and configured the local network, we connect via SSH and determine our disk using the sudo blkid command sudo blkid I used the connection through an active USB hub, because when I connected a portable WD My Passport 1TB drive without additional power, the RPi rebooted and mounted the drive incorrectly. installation and configuration of Avahi and Netatalk daemonsĬonnect and configure external USB drivesĪ disk formatted for the HFS + file system must be connected to external power (or via an active USB hub), then connected to the RaspberryPi.setting automatic mounting of hard drives when turning on / rebooting RPi.connecting and configuring external USB drives.In the configuration process, you will need to go through the following steps: This article is an attempt to create step-by-step instructions on how to configure RPi for use as a Time Capsule. ![]() But waiting for my order for 4 months and surfing the Internet suggested using the Raspberry Pi as a backup copy of the MacBook Pro, i.e., configure RPi (Raspberry Pi) so that the Mac OS X system via local Wi-Fi The network backed up automatically. Raspberry Pi learned about a single-board computer a little more than six months ago and immediately there was a desire to use it as a home media server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |